Download Manual - MattairTech
Transcript
MT-DB-U2 Manual dfuprogrammer dfuprogrammer is a command line utility used to program the ATmega32U2 that runs under Linux. A DFU driver installation is not required. Download version 0.5.4 or higher from http://dfu programmer.sourceforge.net/ . The following commands can be used: dfuprogrammer atmega32u2 erase dfuprogrammer atmega32u2 flasheeprom YourHex.eep (if applicable) dfuprogrammer atmega32u2 flash YourHex.hex dfuprogrammer atmega32u2 start (to jump to application section without reset) October 29, 2015 23 http://www.mattairtech.com/