Download PTS 3.1 C Portable Test System Operation Manual - MTE

Reference power mode for energy measurement and energy dosage
Active power
Reactive power
Apparent power
Register test switched OFF, the corresponding field is blank in
the register test main menu.
Maximum demand period
Time period for maximum demand test in minutes (e.g. typical value: 15 min).
This interval must be manually synchronized with the maximum demand period of the
meter under test by starting the test with the interval start at the meter.
Hint: The maximum demand test is always running and cannot be switched off. If this is
disturbing, a period of 60 min can be entered. In this case WP1(t)/t will indicate the
energy counted up since start in Wh during 1h.
Error tolerance band
Entry of an upper and lower tolerance between ±0.0000... ±100 %.
Enter the amount of energy (W) for dosage
The unit depends on the chosen reference mode.
These setting and input can be defined on input 1
only, valid for all three register tests.
In case
x?x.
is chosen, the unit is shown
Copy parameters from field x (1,2,3) to field y (1,2,3)
The copy function is enabled, if the regions of two fields are selected at the same time.
E.g. copy settings of field 1 to field 2
Activate field 1
The red frame is displayed
around the region of field 1.
Activate region of field 2
and activate copy function
The red frame is displayed
around the region of field 2.
The frame around region of
field 1 becomes blue.
The copy key is enabled. By pressing the copy key all settings are copied from the field
with the blue frame to the field with the red frame. The copy function can be repeated, by
selecting the region of field 3 or field 1. The last input region selected always becomes
the copy destination. The field region selected previously is the copy source
PTS 3.1 C Operation Manual
Page 117/202