Download ATi user manual master

GETTING STARTED
(Again, cursor softkeys ( ← → ) appear in context, and may be used with the
‘Delete’ softkey to correct mistakes.)
Note: Pressing the ‘Abort’ softkey will also take you back to the RUN-FINISH
display, but with no serial number entered. This would be the correct action if
the next softkey you wish to press is FINISH. (Subsequently pressing RUN
would merely return you to the ‘Enter the serial number’ display.)
Re-inputting the Options
When options are enabled, the RUN-FINISH display allows access to
additional softkeys that enable you to change the batch number or operator
name without having to re-enter the test program name. You may access
those additional softkeys via the ‘Settings’ softkey from the RUN-FINISH
display.
To change the batch number, press ‘Settings’, and the following display will be
revealed. Choose the ‘New Batch’ softkey to enter a new batch number at this
time, or to change the operator name, press the ‘Operator’ softkey.
VOLTECH ATI USER MANUAL
PAGE 2-67