Download ATi user manual master
Transcript
PROGRAM EDITOR If you look at the test results screen shown above, you will see that test 4 (LBAL) contains a status error code of 0010. This error code indicates that “The measurement had not settled in time”. Although this test passed, it indicates that a problem existed during the test sequence. In this particular example, the fault was due to a poor connection to the core of the transformer. The following table gives the error codes that can appear when using the run facility in the Editor or when viewing on-line results with the Server. These error codes can give specific help in modifying the test program, depending on the tests used. The error code is a 16-bit binary code, which is shown in hexadecimal notation in the table below. The error codes indicate one single bit of the 16-bit code, and therefore one or more errors could occur at the same time, which will be shown as a full, 4-digit hexadecimal code. For example, if a voltage over-range PAGE 3-44 VOLTECH ATI USER MANUAL
Related documents
ATi USER MANUAL
ATi
工事要領・取扱説明書
工事要領、取扱説明書
3550 Manual
CRW-STA V2
Asus A9200 Series Network Card User Manual
Artisan Technology Group is your source for quality new and
POSITILT® - PTAM/PTDM - Sensori di inclinazione
SAFETY TERMS AND SYMBOLS
ACUCOBOL-GT Appendices v8
AT Series Transformer Testers Calibration System User Manual