Download November 3rd, 2008

Transcript
1-Wire Temperature Sensor Wiring Diagram (CS Alarm Hookup)
(Alarm Control Panel –Communications on Alarm Panel to Central Station)
NOTE: The Alarm/Trouble/Temperature Alarm Outputs on the Network Gateway will require a
network connection to Connect ONE to operate when the condition exists. The Communication
Failure output will work regardless of the network connection which will indicate the central station
that an alarm could be missed because of the communication failure.
Connect output 4 on the gateway to a zone on the alarm control panel. Connect output 2 on the
gateway to a zone on the alarm to indicate general trouble, and output 3 on the gateway to a
zone on the alarm to indicate temperature alarm. Optionally connect output 1 on the gateway to
a zone on the alarm to indicate general alarm, connect outputs on the alarm control panel to the
inputs on the gateway and monitor for ac and low battery conditions. A keypad and sounder may
be connected to the alarm control panel for local annunciation.
IMPORTANT NOTE (Long Wire Runs): Install a 2kOhm pull-up resistor at the Barionet 1W
terminal to the Barionet +5V terminal.
©2014. Updated 4/8/2014
49