Download HITEC DIGITAL SERVO PROGRAM MODE TEST

HPP-21 PLUS Field Manual
NOTE
Please note that this manual is for active users’ convenience using HPP-21 Plus in the field.
- For independent usage without PC in the field, please connect HPP-21 Plus to a battery and a servo only.
(Do NOT connect it with a PC.) Then, only the top LED will light up.
- For PC interfaced application, please refer to the enclosed booklet manual for HPP-21.
Index
Main Menu
Sub Menu
2100us
/
Test
1. (Manual Mode)
Enter
+
Manual Test
1500us
then push
Fail-safe Test
/
3sec
Exit
Potentiometer Knob control
Number indicates its level
Anytime
+
to save
/
/
900us
Sweep (speed)
2.
Test
(Auto Mode)
Enter
+
Anytime
+
/
Exit
EPA Mode
Enter
+
Exit
/
4. Fail-Safe Mode
Enter
+
Exit
/
5.
Speed Mode
+
Enter
+
Exit
/
6. Direction Mode
Enter
+
Exit
/
/
to save
/
3.
Push both Up &
Down button
at the same time.
/
3sec
Step (speed)
Push the
Up button once.
Push the
Down button once.
then push
DB Width Test
7. DB Width Mode
Enter
+
Exit
Push either Up or
Down button.
Set Center and
Erase Left/Right
Move to
Potentiometer
Position
/
Set
Right or Left
Anytime
+
3sec
then push
Set Fail-Safe
Position
Off
(Slow LED Blink)
/
On
(Fast LED Blink)
Display
Saved Value
(Fast Blinks)
10
Display
Potentiometer Value
(Slow Blinks)
Push
/
to save
(Top) = Speed(10%)
(Bottom) = Max. speed(100%)
C.W
Blink slowly
/
C.C.W
Blink Fast
Display
Saved Value
(Fast Blinks)
5
Display
Saved Value
(Fast Blinks)
6
Push
Display
Potentiometer Value
(Slow Blinks)
to save
Display
Potentiometer Value
(Slow Blinks)
to save
/
(Top) = Most sensitive
(5th LED) = Most insensitive
/
8. OLP Rate Mode
Enter
+
Exit
/
+
9. Resolution Mode
Enter
+
Exit
Push both Up &
Down button
at the same time for 3 sec.
/
10.
Reset Mode
Enter
+
Exit
/
to save
High
(Slow Blinks)
/
Normal
(Fast Blinks)
Ready to Reset
(Slow Blinks)
+
3 sec
LED displays
its reset process.
Push
/
(Top LED) = Off
(2nd LED) = 10%
(6th LED) = 50%