Download ^2 Pmac Tuning Pro

PMAC Tuning Pro Software Reference Manual
TOOLS
Configuration
This command displays Configuration Windows. In this window, set P-variables range, M-variables range,
PLC Number, Motion Program Number to use the PmacTuning Program and enable other PLCs or disable
PLCs, when tuning with PmacTuningPro.
P-variables: Set at least 50 variables between Start P-variables and End P-variables.
M-variables: Set at least 50 variables between Start M-variables and End M-variables.
PLC number: Set 2 legal plc numbers to use in PmacTuningPro.
Motion Program: Set 1 legal motion program number to use in PmacTuningPro.
Disable PLCs while testing Checkbox: Enable or disable any other currently running PLCs whole doing
auto tune or trajectories.
Check Sum Enable Checkbox: Set enable or disable when data is uploaded using check sum or not in serial
communication mode.
Save Coordinate Definition Checkbox: Set enable or disable when trajectories are performed to save the
coordinate definition and restore the coordinate definition after done trajectories.
Tools
53