Download configuration

&RQILJXULQJ63$16639&V$0,
myswitch::configuration> spvc ?
spans>
pnni>
myswitch::conf spvc> spans ?
delete
new
show
myswitch::> open 198.29.22.46 private
198.29.22.46::> localhost
myswitch::conf spvc spans> new <port> <vpi> <vci> <dest-session> <dest-port>
<dest-vpi> <dest-vci> [-peak <Kbps>] [(source | destination | bidirectional)]
myswitch::conf spvc spans> new 1c1 0 49 198.29.22.46 1b1 0 50
myswitch::conf spvc spans> show
Local
Remote
ID
Port VPI VCI BW Direction
ID
Port VPI VCI Switch
65364 1C1
0 49 0.0 bidirectional 42591 1B1
0 50 198.29.22.46
myswitch::conf spvc spans> delete 65364
Core Switch
1/27/98 4-26
To configure SPANS SPVCs using AMI commands you will use the
subcommands under “conf spvc spans”.
Before creating a SPANS SPVC from your local ami session, you must
open a private ami session with the remote switch at the far end of your
ATM network.
Then revert to the still open local ami connection and issue the “conf
spvc spans new” command as shown in the example above.
To delete a SPANS SPVC, simply delete the local ID number.
Copyright FORE Systems
1/27/98
Core Switch
4-26