Download user manua l

Remove pin (B) and insert the end of the arm (A) into the base. Re-insert
and screw the pin into place. The cables are threaded up through the center
of the base (as shown) and then through one of the slots in the base.
B
A
8 Connect the data cable (A) to the data terminal (A). Connect the power
connectors (B).
A
B
A
B
9 If the power and data cables are to pass out
through the side of the base cover then
remove the three rubber grommets that sit in
the cover holes, make a cut in each of them,
place them over their respective cables, and
push them back into place on the cover.
26
Installing an Alien 05 Stem Mount