Download - infoPLC

Software
General
You will need to install the Unity Pro programming software for the Premium PLC and
the UniLink software for configuring the servo motors. You will also need the Vijeo
Designer software for configuring the HMI and creating the necessary diagrams. The
PowerSuite software can be installed in order to maximize user-friendliness in respect of
parameterization, archiving and simulation for the variable speed drive (ATV31).
However, this is currently only supported by ATV31 drives (and not ATV71).
The following installation requirements apply in respect of all software packages:
 Operating system: Windows 2000 (SP1 minimum) or Windows XP
 Free hard disk memory: At least 2.4 GB, 4.4 GB recommended
 User memory: At least 512 MB, 1024 MB recommended
 Processor: Pentium III or higher with min. 800 MHz, 1.2 GHz recommended
 Interfaces: Serial interfaces as a minimum, USB recommended in addition
 Additional software: Internet Explorer 5.5 or higher
Software
Premium Lexium Altivar Sercos_EN.doc
Schneider Electric
21