Download PX/QX/RX Version 4.20 User Manual
Transcript
PX/QX/RX Version 4.20 User Manual – Issue B Log Text Det Test Fail Det Test OK Det.Test Fail Dorm Confirm Dorm Init. Download Fail Download OK Enc.Sequence Engineer Reset Entry Alarm Entry Started Expiry Date Ext.Time Failed Auto Set Fault Fault Fault Fault Fault Fault Fault Fire Fire Door Open First code GSM Route Fail GSM Route OK GSR Poll Fail GSR Poll Rest. GSR Rejected Head Count Incorrect PIN Isol. Limit Isolate Isolate Isolate Alarm & Event Log messages Additional Data Display Text Event Description Usnn, Area m Usnn, Am One or more detector test circuits failed Usnn, Area m Usnn, Am All detector test circuits tested OK User nn, Circuit mmm Usnn Cctmmm A detector circuit has failed to respond during a detector test. Circuit nnn Cctnnn Dormitory circuit confirmed Circuit nnn Cctnnn Dormitory circuit first activation GSRx GSRx Download from GSR x failed GSRx GSRx Download from GSR x OK User nn Usnn Encryption sequence fail Circuit nnn Cctnnn Engineer reset type circuit alarms Area n An The area is not unset before the end of the entry warning period Circuit nnn Cctnnn Entry circuit opens Usnn Usnn Config change: User expiry date change. User nn, Keypad m Usnn, KPm ATM user selected a time extension User nn, Area m Usnn, Am Event programmer failed to auto set due to circuits in alarm Radio module number RM nn Radio Module fault (no response when unset). The system fault response option must be programmed. This option is only available in EN50131 compliant variants. Circuit nnn Cctnnn A Circuit short circuit when unset Keypad n KPn Failed poll when unset Conc nn Conc nn Failed poll when unset OPM nn OPM nn Failed poll when unset SM n SM n Failed poll when unset ACM nn ACM nn Failed poll when unset Circuit nnn Cctnnn A fire type circuit alarm Circuit nnn Cctnnn Fire door open when unset User nn, Keypad m Usnn, KPm User entered code on Dual code keypad NONE NONE A call using the Dual comm GSM route has failed. NONE NONE A call using the Dual comm GSM route was successful. GSRx GSRx GSR number x poll fail. GSRx GSRx GSR number x polling restarted NONE NONE A call from an unauthorised GSR was rejected by the panel (the serial number was not programmed) Number Number of activations of all circuits programmed with the head count option while the panel was unset. Keypad n KPn Maximum PIN attempts reached Area n An The isolate limit for the system has been reached. User nn, Circuit mmm Usnn Cctmmm Circuit isolated by user User nn, Concm Usnn, m Concentrator isolated by user User nn, Keypad m Usnn, KPm Keypad isolated by user - 36 -