Download DAS-8000

DAS-8000 ver. 2.5
Initial Status on startup
INITIAL STATUS
ON STARTUP
101
10
do 1 c
Digital Output number
This digit allows you to configure the Initial Status when the
device is started up (after a power failure). The possible values are:
0:
1:
Initial Status at 0.
Initial Status at 1.
Three possibilities can occur:
a) In a standard communication situation, this Initial Status parameter
allows you to predetermine the On/Off Status that digital output of the
Remote Action will assume automatically when the module is started up
after a power failure.
b) If the communication is interrupted for more than 30 sec. and the
Active Security is in 0 (Watch-Dog cancelled) the Initial Status
parameter will act the same as in the previous section a).
c) If the communication is interrupted for more than 30 sec. and the
Active Security is at 1 (Watch-Dog activated), the Initial Status
parameter will be inactive regardless of its value, passing the
responsibility to the Security Status parameter, that will be the one to
impose the Digital Output value of the Remote Action, if there is an
communications error.
NOTE: This parameter works exclusively in Remote Activation.
Configuration / 112