Download DAS-8000

Transcript
DAS-8000 ver. 2.5
Locating failures
EFFECT
Display always indicates Err1
Display indicates OVEr
Display indicates UnDE
The display does not
illuminate or lights up weakly.
In the display it indicates (-)
signal, but the signal is
positive.
The measurement is indicated
with an error.
The reading is correct up to a
point in which it is saturated
under the maximum of scale.
The reading is erroneous and
fluctuates periodically,
displaying OVEr, Err 1,
and UnDE messages.
The reading is correct but
there are sporadic leaps or
fluctuations on the display
Maintenance / 168
CAUSE
It can originate due to loss of calibration,
breakdown of the receiver, etc.
Reset by disconnecting from electrical power for
10 sec.
Recalibrate or retrieve "factory settings".
Value of signal above the maximum of the
scale.
Pt-100 Probes or mA line open.
Communication to ground or to electrical power
of network of the analog input signals.
Value of signal lower than the minimum of the
scale
Pt-100 Probes or mA line short-circuited.
Communication to ground or to electrical power
of network of the analog input signals.
Failure of electrical power: Low or fluctuating
electrical power. Electrical power of 110V. in
the input for 220 V. Excessive heat within the
unit.
Signal with connection inverted in the receiver,
transmitter, converter or input terminals.
Incorrect signal, or mA Shunt inadequate.
Receivers installed incorrectly.
If the error is constant in origin, it can be
corrected with the Indication OFFSET.
In 4-20 mA inputs, the serial loads are over the
VDC voltage of the electrical power of the
transmitter.
Weak connections. Signal lines have parasites.
Pt-100 Probes have bad contacts. Receiver
installed incorrectly.
Line of input signal or of electrical power has
many parasites. Activate peak filters.