Download fulltext - DiVA Portal

Appendix C Command line parameters
The only parameter that cannot be omitted is the name of a
configuration file
The evoking syntax in BNF notation is the following:
<program name> <config file name> {[-m] | [-t name] | [-s name]}
The additional parameters can be given in any order after the
configuration file name.
-m
Creates makefile for VCOM. If such a parameter is given,
the tool creates file called ‘makefile’, containing all the components of
ready FAD, enumerated in proper order. It allows removing the
interdependency problem during compilation the VHDL code. VCOM
compiler should be evoked in the following way: vcom –f makefile.
-t
Defines name used as a key part of converter type file name.
If the option is not given, ‘noname’ is used as a part of typefile.
-s
Simulates and writes simulation results into file with
filename supplied. Simulation results are just a set of strings like the
following:
0000000000000100
0.000122
0000000000101000
0.001221
1111111111001000
-0.001709
0000001000000000
0.015625
0000000110010000
0.012207
0000001100101000
0.024658
0000001000110000
0.017090
0001010101011100
0.166870
1101110010111000
-0.275635
0000011101110000
0.058105
1111110111100000
-0.016602
1111111111000000
-0.001953
67