Download Preface - Spectrum Controls, Inc.
Transcript
42 SLC 500™ Isolated Analog Output Modules Standing Clear Of Machinery – When troubleshooting a problem with any SLC 500 system, have all personnel remain clear of machinery. The problem may be intermittent, and the machine may move unexpectedly. Have someone ready to operate an emergency stop switch. ! CAUTION POSSIBLE EQUIPMENT OPERATION Never reach into a machine to actuate a switch. Also, remove all electrical power at the main power disconnect switches before checking electrical connections or inputs/ outputs causing machine motion. Failure to observe these precautions can cause personal injury or equipment damage. Safety Circuits – Circuits installed on machinery for safety reasons (like over-travel limit switches, stop push-buttons, and interlocks) should always be hard-wired to the master control relay. These circuits should also be wired in series so that when any one circuit opens, the master control relay is de-energized, thereby removing power. Never modify these circuits to defeat their function. Serious injury or equipment damage may result. Refer to your system’s Installation & Operation Manual for more information.