Download PMAC Plus

PMAC Plus
Installation and Operating User Manual
Accessing a Log
To open a log:
1. Select LOG REPORT from the UTILS menu in
a PMAC window.
2.
The PMAC Log View window opens with the
New window (right) inset.
3.
To start a new log, select the required type from
the New window and click OK.
4.
To open a previously saved log, close the New
window, select OPEN from the FILE menu and
select the required log.
Alarm Log
Alarm Log
window
Log View
window
Alarm Sources
Alarms can be originated by a logger and can be generated by a variety of events, depending on the
logger set up (Set up using the Logger Settings Editor). For example, alarms could indicate door
switch activation, logged pressure dropping below a set value or the logger battery charge falling
below minimum. The alarm is passed through the modem/telephone link to the PC.
Note: Logger alarms can be generated from all E5565 protocol loggers and from GPS protocol Utilog and
Newlink loggers. All other GPS protocol loggers cannot produce alarms unless connected to a “Dialog 377”
unit.
There are also many internal alarms, which can be generated by the PMAC program. For example,
failure to poll a certain logger (Communication Failure alarm), failure to open a comms port on the PC
etc.
UGZ19000 Issue 2
Page 112 of 176