Download Introduction and Overview Guide

Transcript
classification variable which splits the difference between the variant and the base benefits,
split into four groups, Min-0, 1 – 200, 201-400, and 400+. gotvar will be equal to 1 when
a person received variant benefits and zero otherwise.
Finally, we now want to create new output tables. We will need to edit two more control
parameters, XTFLAG and XTSPEC. The former turns on the user-tabulation facility, while
the latter will define the tables.
Open the two parameters, using the edit box. Tick on XTFLAG to produce tables and then
enter the following in XTSPEC.
IN: {_imfcbene, imfcbene, @imfcbene, @imfcbene/units,
@imfcbene/gotvar:L="Average change in NCBS"};
IN: spdiff+ * {gotvar:S=0, gotvar:M=spdiff L="Distribution of
recipients"};
CF: cfnkids+ * {@imfcbene, @imfcbene/gotvar:L="Average change", spsdrecs};
This will produce three user tables. Each table request ends with a semi-colon, and each
starts with a prefix indicating which family level is being tabulated. So the first table is a
table of individuals while the third is a census family table. See the User’s Guide or XTab
User’s Guide, for more information about creating tables. At this point save the simulation
and run the model. You can then open the three user tables. We will go through them one by
one.
Introduction and Overview Guide
SPSD/M Version 16.1
Page 45