Download SYSMAC WS02-CXPC1-EV3 CX-Programmer Ver.3.1

PART 1: CX-Programmer
CHAPTER 2 – Quick Start Guide
OMRON
14. Place a New Contact at the start of the next rung to display the New Contact dialogue.
15. Select ‘AmberTimerDone’ from the combo and select the OK pushbutton. When a
comment dialog is displayed, select the OK pushbutton again.
16. Place an instruction next to the Contact and display the New Instruction dialogue. Enter
the instruction ‘TIM’ and the two operands ‘GreenLightTimer’ and ‘TimeInterval’ in the
edit box. When a comment dialog is displayed, select the OK pushbutton again.
17. Select the OK pushbutton to accept the settings in the New Instruction dialogue. When a
comment dialog is displayed, select the OK pushbutton again.
18. Give the instruction the comment ‘Green light on only’.
19. Place a New Contact at the start of the next rung to display the New Contact dialogue.
20. Select ‘GreenTimerDone’ from the combo and select the OK pushbutton. When a
comment dialog is displayed, select the OK pushbutton again.
21. Place an instruction next to the Contact and display the New Instruction dialogue. Enter
the instruction ’TIM’ and the two operands ‘AmberOnlyTimer’ and ‘TimeInterval’ in the
edit box.
22. Select the OK pushbutton to accept the settings in the New Instruction dialogue. When a
comment dialog is displayed, select the OK pushbutton again.
23. Give the instruction a comment of ‘Amber light on only’.
The Ladder Program should resemble that illustrated (depending upon the display options chosen).
Use the following procedure to place an output for each of the traffic lights into the program.
1, 2, 3…
1.
Ensure the Ladder program is displayed in the Diagram Workspace.
2.
Place a New Contact at the start of the next rung and assign it to symbol ‘RedTimerDone’
(select the symbol name from the combo on the New Contact dialogue.
CX-Programmer _Page 20