Download Model 2000 Multimeter

Measurement Options
3-19
Setting limit values
Use the following steps to enter high and low limit values:
1.
Press the SHIFT-LIMITS keys to view the present HI limit value:
HI:+1.000000 ^
This value represents the absolute value of that function.
2.
3.
Use the
,
, ▲, and ▼ keys to enter the desired value. Move the cursor to the rightmost position and use the ▲ and ▼ keys to move the decimal point.
Press ENTER to view the present LO limit value:
LO:-1.000000 ^
This value represents the absolute value of that function.
4.
Enter the desired value for the low limit. Pressing ENTER returns to the normal display.
Enabling limits
Use the following procedure to turn on the limits operation:
1.
Press the SHIFT-ON/OFF keys to view the present beeper status:
BEEP: NEVER
2.
Use the ▲ and ▼ keys to change the beeper status (NEVER, OUTSIDE, INSIDE). Press
ENTER when done.
When the multimeter returns to the normal display, the HI/IN/LO status is displayed along
with the reading. To disable limit testing, press SHIFT-ON/OFF again. An example of using
limits to sort resistors is shown in Figure 3-11.
Figure 3-11
Using limit test to sort
100Ω, 10% resistors
LO
90Ω
LO Limit
IN
HI
110Ω
HI Limit