Download iPortal User Manual

4.2. Step 2 - pair the iPortal and the iOS device
Your iOS device communicates with the Shark, DX or DX2 wheelchair control system
via the iPortal module, using a Bluetooth® wireless link. Before using your iOS device
with your wheelchair control system, you must first pair (this means establish a
Bluetooth connection) your iOS device with the iPortal.
To pair the devices, start from your iOS device Home screen. (The numbers in square
brackets refer to the images below).
- Browse to Settings [1] ► General [2] ► Bluetooth [3]
- Turn on Bluetooth [4]. Your iOS device will start searching for nearby devices
- On the wheelchair, turn the power off and on [5]
- On your iOS device, when asked for a PIN, enter 7654 [6]
- Tap Connect at the top of the iOS device‟s screen [6]
NOTE
Allow between 30 and 60 seconds for the Enter PIN screen to be
displayed.
NOTE
When you see an instruction on your iOS device to “cycle the
power”, turn the power off at your Remote, and then turn it on
again.
11
Setting up the iPortal with your iOS device