1
Download MultiCam® Laser User Manual
Transcript
CN 10 Innovation. Quality. Performance. Best in Industry. Worldwide. 5. Select Yes at the prompt to upload the modules from the controller and load the XMI file. This will assign a connection name to the machine. Connect Ethernet Cables If the company has an established network, then the computers are probably already connected through a hub or switch. A patch cable is a standard cable used to connect a network device consisting of a computer, a network printer, and a MultiCam Controller to a hub or switch. However, the patch cable is unable to provide a direct connection with the MultiCam Controller, so the host PC must be connected through a switch or hub. RJ45 Patch Cable A patch cable is also known as a straight-through cable. The wires are in the same order on connector 1 as they are on connector 2. The RJ45 connectors are used on each end of the cable, and operators must verify that the connectors are being held the same way when checking. Connect Connector 1 Connector 2 Pin 1 Pin 2 Pin 3 >>> >>> >>> Pin 1 Pin 2 Pin 3 etc... >>> etc... Routers * Lasers * Plasma * WaterJets * Knife Cutters www.MultiCam.com v. 11 10
