Download E2 Host Manual
Transcript
Warning It is crucial that you read this entire section prior to performing a Force switchover. Performing this command forces the standby Matrix card in the EXS Switch to become active. When the switchover occurs, board status messages are sent from the EXS Switch to the new active Host. After the board status messages have been received from the Matrix card, the Host will delay approximately one minute prior to running the startup routine. This can be easily monitored by watching the debug screen. When a system is first brought on line (Host systems active), a forced switchover should be performed. Warning If you use Force switchover to manually switch over from the active Host to the standby Host, you will lose all calls being set up. To verify that the switchover was successful, do the following: 1. Query a channel from the now active Host. Verify that the Host can communicate with the EXS Switch. 2. Query a channel from the now standby Host. An "invalid matrix state" message should appear on the screen. Page 252