Download User Guide - HSM Performance Pack for Mastercam

Mastercam HSM Performance Pack User Guide
57
The rest material dialog for adaptive clearing looks like this:
Rest material source selects the method for calculating the remaining
material to be removed by this operation:
Disabled: This is not a rest material operation; the operation
must be machined normally.
Rest material operation: The remaining material must be
calculated as the material left behind by one or more earlier
operations. This is the most correct method to use, as it works
from where the tool actually went in the earlier operation, taking
the room needed for lead in/out motion into account, as well as
any other limitations of the earlier operations. This is also the
only way to take more than one operation into account.