Download Undertow Suite

Chapter 7:
Undertow Suite Reference Manual
Displaying a signal from source code window
Any time a module is selected, the variables of that module are displayed in the signal selector
(the pane below the module pane). You can select a signal, or any number of signals, then
with the middle mouse button held down, drag the signal(s) to the area of the waveform
window which displays the variable names (left pane of wave window). Or you may press the
“Display” icon (icon furthest to the left in the source code window). With the “Display”
button toggled down, you can now select any number of signals and they will be automatically
displayed in waveform window.
A third way to display signals in the waveform window from the source code window is by
using a drag and drop directly from the source code window. From the source code window
select with the middle mouse button any signal name, while holding the middle mouse button
down drag the signal to the signal name area of the waveform window. When you release the
middle mouse button while over the Waveform window, the selected signal will be
displayed.
Finding source code from the signal window
In the Signal Window select the snap to source icon, it should darken Then use the middle
mouse key to snap the cursor to the edge of the signal. The Undertow Suite Source Code
window will display the exact line of code used to generate that particular signal edge.
331
Undertow Suite Proprietary and Confidential Copyright Veritools 2004
All Rights Reserved