Download Horizon Programming Manual

Basic Programming and Testing
Enter the minimum resistance measurement for the Isolation
test in kΩ.
Select Enter to continue.
To restore the Quick Scan setting, simply select Isolation Min Res again.
Select Conductor Res to select a measured value for the Continuity measurement.
Select the desired Continuity Type.
For this exercise, select Resistance @5mA.
Resistance @5mA
MSR measured scan.
Quick Scan
As described above.
HC Resistance
Programmable HCS measured scan. (Resistance reference)
Voltage Drop
Programmable HCS measured scan. (Voltage reference)
From Sample
Uses the MSR to measure the maximum resistance for the
attached nets. Set the Maximum Conductor Resistance accordingly.
Fixed HC
Measured scan using the Fixed HCS. (Voltage or resistance
reference).
The Fixed HC option can only be used for 4-wire measurements.
Enter the maximum conductor resistance (measurements
made higher than the value entered will be considered
opens).
Select Enter to continue.
Horizon Series Tester: Programmer’s Manual 4-17