Download NetCamPro User Manual Cloud

NetCamPro Cloud App User Manual 2015-01-28
2) Click the Choose File button above and browse the config.cfg file. Click the
Upload button.
3) Save the new_config.cfg file to your device
4) Upload the new_config.cfg file to your camera using the Restore function. Then
reboot the camera.
Removing a Camera
To remove a camera click the Release button. The camera will disappear from the
Cameras page and will be available for another user to add to their account. If you sell or
pass on your camera you will need to Release it for another user to be able to connect it.
Also be aware that any images stored in the cloud by this camera will remain there. When
another users adds this camera to their account they will see all the images that were
there when the camera was released. If this is not your intention then you should make
sure to delete all the images with the Manage Media function on the Cameras page before
releasing.
Modifying Camera Parameters
To properly process the images and videos the Cloud App needs to know the timezone
that the camera is using. By default the cameras are set to use the UTC timezone,
however some users may change this in the camera's admin settings. In these
circumstances users will be required to change the camera's time zone in the Cloud App
so the camera and cloud can be in sync. If this value is not correct the timestamps on
images and videos will be off by a consistent number of hours.
In order to calculate sunrise and sunset the Cloud App needs to know roughly where the
camera is on the planet's surface. You can enter the longitude and latitude if you have that
information at hand. Alternatively you may enter a city and country that is close to the
camera' location and the Cloud App will look up the latitude longitude for you.
The Zenith is the solar zenith angle. The default value is 90.3333 degrees.
33