Download Q Corresponding Ethernet Interface Module User`s Manual

Transcript
CHAPTER 16 TROUBLESHOOTING
Error
Error description
code
Action
• Follow the procedure below.
(1)
Check if each module is properly mounted on the base unit.
(2)
Check if the operating environment of the Ethernet module
(3)
Check if the power capacity is sufficient.
(4)
Check if the hardware is normal according to the manual for
conforms to the general specifications of the CPU module.
C0DFH
System error (The OS detected an error.)
each module.
If the actions above do not solve the problem, please consult your
local Mitsubishi representative.
• Check that the CPU module and each intelligent function module
are properly mounted on the base unit.
• Check that the programmable controller CPU is not in the reset
C0E0H
An error was detected in the programmable controller
CPU.
status.
• Check if an error exists in the programmable controller CPU. If an
error exists, take the action required to correct it.
• Replace the power supply module, programmable controller CPU,
or intelligent function module.
• Check that the CPU module and each intelligent function module
are properly mounted on the base unit.
• Check that the programmable controller CPU is not in the reset
C0E1H
An error was detected in the programmable controller
CPU.
status.
• Check if an error exists in the programmable controller CPU. If an
error exists, take the action required to correct it.
• Replace the power supply module, programmable controller CPU,
or intelligent function module.
16
• Check that the CPU module and each intelligent function module
are properly mounted on the base unit.
C0E2H
An error was detected in the programmable controller
CPU.
status.
• Check if an error exists in the programmable controller CPU. If an
error exists, take the action required to correct it.
• Replace the power supply module, programmable controller CPU,
or intelligent function module.
• Check that the CPU module and each intelligent function module
are properly mounted on the base unit.
• Check that the programmable controller CPU is not in the reset
C0E3H
An error was detected in the programmable controller
CPU.
status.
• Check if an error exists in the programmable controller CPU. If an
error exists, take the action required to correct it.
• Replace the power supply module, programmable controller CPU,
or intelligent function module.
• Check that the CPU module and each intelligent function module
are properly mounted on the base unit.
• Check that the programmable controller CPU is not in the reset
C0E4H
An error was detected in the programmable controller
CPU.
status.
• Check if an error exists in the programmable controller CPU. If an
error exists, take the action required to correct it.
• Replace the power supply module, programmable controller CPU,
or intelligent function module.
315
16.6 Error Code List
16.6.3 Error codes stored in the buffer memory
• Check that the programmable controller CPU is not in the reset