Download Altivar 71
Transcript
Contents Before you begin_____________________________________________________________________________________________ 4 Documentation structure_______________________________________________________________________________________ 5 Introduction _________________________________________________________________________________________________ 6 Presentation _____________________________________________________________________________________________ 6 Notation ________________________________________________________________________________________________ 6 Bus connection ______________________________________________________________________________________________ 7 Connecting to the Altivar 71 _________________________________________________________________________________ 7 RJ45 connector pinouts ____________________________________________________________________________________ 7 Wiring recommendations ___________________________________________________________________________________ 8 RS485 standard __________________________________________________________________________________________ 8 Modbus standard schematic_________________________________________________________________________________ 9 Connection via RJ45 wiring system __________________________________________________________________________ 10 Connection via junction boxes ______________________________________________________________________________ 12 Connection onto screw terminals ____________________________________________________________________________ 14 Configuration ______________________________________________________________________________________________ Configuring communication parameters _______________________________________________________________________ Control-signal configuration ________________________________________________________________________________ Configuring the communication scanner ______________________________________________________________________ Configuring monitored parameters ___________________________________________________________________________ Configuring communication fault management _________________________________________________________________ 15 15 16 19 20 21 Diagnostics ________________________________________________________________________________________________ LEDs __________________________________________________________________________________________________ Communication diagnostics ________________________________________________________________________________ Control-signal diagnostics__________________________________________________________________________________ Communication faults _____________________________________________________________________________________ 22 22 23 25 27 Modbus protocol ____________________________________________________________________________________________ RTU mode _____________________________________________________________________________________________ Principle _______________________________________________________________________________________________ Altivar 71 Integrated Modbus _______________________________________________________________________________ Addresses______________________________________________________________________________________________ Modbus functions ________________________________________________________________________________________ Read N output words: Function 3 ____________________________________________________________________________ Write one output word: Function 6 ___________________________________________________________________________ Diagnostics: Function 8 ___________________________________________________________________________________ Write N output words: Function 16 (16#10) ____________________________________________________________________ Identification: Function 43 (16#2B) ___________________________________________________________________________ Read/write N words: Function 23 (16#17) _____________________________________________________________________ Communication scanner ___________________________________________________________________________________ Exception responses _____________________________________________________________________________________ Read non-existent or protected parameters ____________________________________________________________________ 28 28 28 29 29 30 30 31 32 33 34 36 37 39 39 Appendix: Non-standard schematics ____________________________________________________________________________ UNI-TELWAY schematic __________________________________________________________________________________ Jbus schematic __________________________________________________________________________________________ Use of UNI-TELWAY slaves in a standard schematic ____________________________________________________________ Recommendations for setting up a Modbus network using non-standard devices_______________________________________ 41 41 42 43 44 While every precaution has been taken in the preparation of this document, Schneider Electric SA assumes no liability for any omissions or errors it may contain, nor for any damages resulting from the application or use of the information herein. The products and options described in this document may be changed or modified at any time, either from a technical point of view or in the way they are operated. Their description can in no way be considered contractual. 3