Download Behavioral Core User Manual
Transcript
Rotarod This test is used to examine sensorimotor functioning in animals, and can also be used to test physical stamina. You are able to run up to 4 animals at a time on a rotating rod that has the capacity to accelerate up to 99.9 RPM. Photobeams record when the animal drops off of the rod. 1. Get your animals from Suite 16 and bring them to the room for acclimation. Computer/Experimental Setup: 2. Turn the Rotamex‐V on, and make sure the computer is on. The rotarod MUST be on before you click on the icon to start the program. 3. Double‐click on the Rotamex icon on the computer desktop. It will find the port automatically, and then scan for all devices (which should read OK for the first port) and take you to the menu screen. 4. Go to Experiment. This should pop up a screen where you can enter in parameters. 5. First make sure that speed is in RPM, and you have selected the correct wheel (mouse or rat). This should correspond with the type of rod that is on the machine. 6. Enter your experiment duration in seconds. For most protocols, this will be 300 sec (5 min). Then enter your starting speed. This is recommended to be 5.0 RPM. Your Max speed will be up to 99.9 RPM. 7. Acc Int means the acceleration interval; in other words, how often the rotarod is getting faster. We recommend increasing it every 5 seconds. Acc step means how much faster it will get every interval, which we recommend 1.0 RPM. 8. Push “Subject ID” for each animal you want to load (you will do this one at a time). Enter in the subject ID information and push ok for each animal. Each Channel corresponds to Channels 1‐4 on the rotarod, so make sure that you load each animal where you entered their information. 9. When you are ready, load the animals on the rotarod, and push “start experiment.” 10. You must push each channel start button and then PUSH ENTER. The time/recording will not start until you push enter. As you push each button, it will state that it is loaded. 11. The trial will end when all animals have fallen. Push “Stop Experiment” when all animals have fallen. Save your data to your flash drive by selecting the correct directory and if you are doing another trial, then you are now ready to repeat steps 8‐11. If you are running the same animals, you do not need to re‐enter the subject data, only to do steps 9‐11. Data Analysis: 12. Data files are saved as CSV files and are easily imported into Excel. You may want to look at average RPM speed, or latency on the rotarod when doing analyses. 34