Download Version 2.4.3 User Manual

User Interface
You use Motor step rate numerical input to specify the rate of the
motor stepping. This numerical input accepts integer numbers only.
The range of accepted values is 20…4000 for control units with
firmware older then 1.07, and 30…30000 for firmware version 1.07
and above.
You use Position reference numerical input to change the current
position reference value. This numerical input accepts integer
numbers only. The range of accepted values is ±8000000.
You use Units per step numerical input to specify delay scale
calibration in physical units. This numerical input accepts real
numbers. The absolute value must be in the range of 10-100…10100.
You use Units name text input to specify the physical units name to
be displayed by the program. The length of the text in this input is
up to 16 characters.
3.8.2.3.
Data Acquisition page
You use the Data Acquisition page to specify absorbance spectra
acquisition modes and parameters. The Data Acquisition page in its
turn has a number of sub-pages.
Parameters sub-page
You use Parameters sub-page of the Data Acquisition page to
specify acquisition mode and counters. The Parameters sub-page of
the Data Acquisition page is shown in Fig. 24.
Fig. 24. Parameters sub-page of the Data Acquisition page
43