Download "user manual"

Spindle
Distinctive features
Reset during gear
stage change
z
The acceleration is defined in MD: SPIND_OSCILL_ACCEL (acceleration
during oscillation).
z
If the IS “Oscillation speed” (V38032002.5) is reset, the oscillation motion
will stop. However, the spindle oscillation mode will not be left.
z
The spindle override switch is disabled (fixed to 100%). An exception is
only the position 0%.
z
The IS “Reset” (V30000000.7) will not abort oscillation mode.
z
When indirect measuring systems are used, the synchronization gets
lost.
No spindle stop is possible due to
z
IS “Reset” (V30000000.7)
z
IS “NC Stop” (V32000007.3)
if
z
the spindle is in oscillation mode for gear stage change
z
the IS “Gear stage changed” (V38032000.3) is not yet present.
In these cases, when Reset is selected, the alarm 10640 “Stop during gear
stage change not possible”.
After the gear stages have been changed, the Reset request is carried out and
the alarm deleted if this is still present on the interface.
Note
Only possibility of abortion:
IS “Clear distance to go/spindle reset” (V38030002.2) (own spindle reset)
active.
9-12
SINUMERIK 802S/C base line
Description of Functions