Download XBee-PRO 900HP/XBee-PRO XSC RF Modules

Key features
XBee-PRO XSC RF Module specifications
Specification
XBee-PRO XSC (S3 Hardware)
XBee-PRO XSC (S3B Hardware)
Supply Voltage
3.0-3.6 VDC regulated
2.1 to 3.6VDC
Receive Current
65mA
26mA typical
Transmit Current
265mA
215mA at 24dBm
Power Down Current
50uA
2.5uA typical @3.3v
Power Requirements
General
Frequency Range
902-928MHZ (located in the 900MHZ ISM Band)
Spread Spectrum
Frequency Hopping
Network Topology
Point-to-Point, Peer-to-Peer, Point-to-Multipoint
Channel Capacity
7 hop sequences share 25 frequencies
Board-level Serial Data
Interface (S3B)
3V CMOS UART (5V-tolerant)
3V CMOS UART
Physical Properties
Module Board Size
1.297" x 0.962" x 0.215 (3.29cm x 2.44cm x 0.546cm)
Note Dimensions do not include connector/antenna or pin lengths
Weight
5 to 8 grams, depending on the antenna option
Connector
2 rows of 10 pins, 22mm apart with 2mm spaced male Berg-type headers
Operating Temperature
-40 to 85º C (industrial)
Antenna Options
Integrated Wire
¼ wave monopole, 3.25” (8.26cm) length, 1.9dBi Gain
RF Connector
Reverse-polarity SMA or U.FL
Impedance
50 ohms unbalanced
Certifications
FCC Part 15.247
MCQ-XBEEXSC
MCQ-XBPS3B, or MCQ-XB900HP
(see Using this manual on page 11)
Industry Canada (IC)
1846A-XBEEXSC
1846A-XBPS3B, or 1846A-XB900HP
(see Using this manual on page 11)
Europe
N/A
RoHS
Compliant
Australia
N/A
XBee-PRO 900HP/XBee-PRO XSC RF Modules User Guide
C-Tick
130