Download I. Introduction - Veterinary Technics

II. Installation
1. ECG/Temp module
The Monitor comes standard with an ECG/Temp module. Connect the ECG/Temp module to
ECG&TEMP port on the Monitor.
For monitoring, affix the ECG/Temp module to the dental or surgical table with the attached
Velcro strip. Place the module underneath the dental table to prevent it from being wet.
2. Esophageal probes
The Monitor comes standard with two esophageal probes of different sizes. The one labeled
CAT is for kittens, cats, puppies, and very small dogs, while the one labeled DOG is for dogs
from small to large sizes. The esophageal probes are connected to the ECG/Temp module.
3. ECG leads with flat clips
The ECG leads with flat clips consist of three wires (green, red, and white), each with a flat
metal clip. The flat clips are to be connected to the ECG/Temp module.
4. Resp. module and sensor
The Monitor comes standard with a Resp. module and a Resp. sensor. Connect the sensor
to the module, and then connect the module to Resp/CO2 port on the Monitor.
-2-