Download GP7000F M800, M1000, M2000

2.2 Installing the PGX32 Driver
(29) The "Customize Disks" menu appears. Set disk partitioning by following the
rules described below.
(a) Enter "swap" to the left column of Item 1 in the window. Then, enter "512"
to the right column as disk capacity.
Slice Mount Point
0
Size(MB)
1 swap
512
2 overlap
xxxx
(b) Move the cursor to the left column of Item 0, then enter "/". At this time,
free disk space in unit of M byte is shown in the "Free:" field at the lower
part of the window. Subtract 20 from this value, and enter the resulted value
to the right column of Item 0 (The following table shows an example value
that represents yyyy M bytes).
Slice Mount Point
0 /
1 swap
2 overlap
Size(MB)
yyyy
512
xxxx
A message "Rounding Error 1MB" can be displayed in the lower part
of the window. The users can ignore this message since there is no
impact on the installation.
(30) Press the F2 key.
(31) The "File System and Disk Layout" menu appears. Check that the partition set
in step (27) is selected, then press the F2 key.
(32) The "Mount Remote File System?" menu appears. Press the F2 key.
(33) The "Profile" menu appears. Press the F2 key
Although the "Warning" menu appears, there is no impact on installation. Press
the F2 key.
(34) The "Reboot After Installation?" menu appears. Press the F2 key.
This operation starts up installation.
It takes about 1 hour to complete installation.
7)
2.2
Set a root password. The screen requests to enter password twice. Enter the same
password for both.
Installation is completed when the Login screen appears.
Remove the CD-ROM disk.
Reconnect the LAN cables.
The SMC is not enabled to control the GP7000F system yet because System
Console Software is not installed. To install System Console Software, follow the
procedures described in Section 2.2, "Installing System Console Software to SMC."
Note that CDE is adopted for the window environment of SMC. Be sure to select
CDE at login.
Installing the PGX32 Driver
After installing Solaris, the PGX32 driver must be installed. Read the manuals with the
PGX32 card thoroughly and pay special attention to the precautions. Install the PGX32
driver according to the instructions and information available in the manuals.
C120-E067-01ENU41150-J-Z816-1-76
2-3