1
Download User Manual
Transcript
3.4.2.3 Command Register (CR) (04H) Prior to clearing the command request bit (CO) in the control register, the user must first test that the command register is clear. When the command register is clear the user can insert the next command to be executed. After the command is loaded, bit CO in the control register can be cleared. When the command register clears, the board is ready for a new command. Refer to table 3-2. Table 3-2. Command Register (CR) CODE 0000H 0001H 0002H 0003H 0004H 0005H 0006H 0007H 0008H 0009H 000AH 000BH 000CH 000DH 000EH 000FH 0010H NOTE: PAUSE = Stop the Local clock. U U M R B UM M 111000999888666 R Reeevvv B B COMMAND Illegal GO TO BC MODE GO TO MRT MODE GO TO MON MODE BC COLD Start BC WARM Start BC STOP MRT COLD Start MRT WARM Start MRT STOP PAUSE UNPAUSE LOAD CLOCK SELFTEST RUN MONITOR STOP MONITOR Synchronise CLOCK UNPAUSE = Restart the Local Clock. - 21 -
