Download AVT 100

Transcript
im Vertrieb
Operation,
cont’d von
CAMBOARD Electronics
Buttons on the AVT 100 IR Remote
In Preset mode, the next or previous preset channel is displayed,
depending on which part of the button you pressed. The
AVT 100 briefly displays the preset number preceded by a P,
then it displays the channel number associated with that preset.
The following functions are available through the buttons on
the IR Remote for AVT 100.
3
MUTE
VIDEO
CHANNEL
4
TUNE
N
5
2
1
AUDIO
If no presets have been defined when the Channel button is
pressed, the display shows P00, then the channel number to
which the AVT 100 was set before entering preset mode.
PRESET
6
0
CHANNEL
1
2
3
4
5
6
7
8
9
ENTER
SAVE
3
Video Mute — Press this button to toggle video muting on and
off. When muting is on, video output is mute.
4
Audio Mute — Press this button to toggle audio muting on and
off. When muting is on, audio output is mute.
5
Tune — Press this button to switch to tune mode. In tune mode,
the Channel buttons switch between channel numbers.
6
Preset — Press this button to switch to preset mode. In preset
mode, the Channel buttons switch between preset channels.
7
Save — After keying in a preset number, press this button to
save the currently selected channel as a preset.
8
Enter — After keying in a channel number, press this button to
switch to that channel.
7
8
AVT 100 REMOTE
The Channel Up/Down button applies to Antenna (TV)
and Cable modes. Use the DIP switch on the rear panel
to change between Antenna and Cable modes.
Buttons on the AVT 100 remote control
Selecting a channel (tuning) using the IR Remote
1
Channel Selection (0 through 9) — In tune mode, press these
number buttons to specify a channel number, then press Enter
to select it.
To select or change a channel using the AVT 100 IR Remote,
follow these steps:
1.
In preset mode, pressing these buttons also selects the channel
whose number(s) you pressed. The buttons do not select preset
numbers.
2
Channel Up/Down — Press the up and down arrows on this
rocker button to increment and decrement the channel or preset
number.
In tune mode, pressing either part of this button displays the
adjacent channel number. If an Auto-Scan has been performed,
pressing the Channel button causes the display to cycle between
the channels that were set by the scan for the mode (TV or
cable) in which the scan was done. (In this case, the adjacent
channel may not be available for display.)
3-8
www.camboard.de
AVT
100 • Operation
Tel. 07131 911201
Fax 07131 911203
Using the IR Remote channel selection number buttons in
the same way you would use the number keys on a
calculator, enter the number of the desired channel.
Example: To change to channel 105, press the buttons
numbered 1, then 0, then 5.
2.
Press the Enter button to activate the channel change. If
the number you entered is a valid channel, the AVT 100
switches to it, and the number remains displayed on the
AVT 100 front panel.
If you enter an invalid (out of range) channel number, after
3 seconds the front panel display returns to the channel
number that was displayed previously, and does not
change the channel.
[email protected]
AVT 100 • Operation
3-9