Download Team Name: iSEDE

Transcript
Student Experiment Documentation
Page 53
4.2.1.2 Cameras
The cameras require a clear view to the deployed payloads and therefore they
are mounted directly opposite the deployment modules. A sliding fit bracket
with M4 screw and washer fixing around a square cross section tube is used
which is in turn clamped directly to the gondola frame, as shown below. A
plate is welded to each end of the aluminium tube cross beam and then fixed
to the gondola with M8 bolts to the clamp counterpart.
Figure 4-6: Camera interfaces
4.2.2 Electrical
The hub and satellites interface with the BEXUS link through a 4 pin, male,
box mount receptacle MIL – C-26482P series 1 connector with an 8-4 insert
arrangement (MS3112E8-4P) shown below,
BX16_iSEDE_SEDv5-1-31JAN14