Download Programming & Operation Manual

Program Menu Navigation
Primary Menu
Sub Menu
FREQUENCY SETTING
PARAMETERS
Preset Speeds
Parameter Name
#5 Frequency & Characteristics
F022
#6 Frequency & Characteristics
F023
#7 Frequency & Characteristics
F024
#8 Frequency & Characteristics
F287
#9 Frequency & Characteristics
F288
#10 Frequency & Characteristics
F289
#11 Frequency & Characteristics
F290
#12 Frequency & Characteristics
F291
#13 Frequency & Characteristics
F292
#14 Frequency & Characteristics
F293
#15 Frequency & Characteristics
F294
Preset Speed Mode
Use Preset Speed Mode Enable/Disable
F380
Fwd/Rev Disable
Disable Forward Run/Disable Reverse Run
F311
Motorized Pot Setting Disposition at Power
Down
F108
Motorized Pot Settings
Minimum Frequency
Maximum Frequency
PROTECTION
PARAMETERS
Dynamic Braking
(Not used with this system)
Stall
DC (Injection) Braking
Emergency Off Settings
Retry/Restart
Configuration
36
Parameter
Number
N/A
Dynamic Braking Enable/Disable
F304
Dynamic Braking Resistance Capacity
F309
Dynamic Braking Resistance
F308
Over-current Stall Level
F601
Over-voltage Stall Enable/Disable
F305
Over-voltage Stall Level
F626
Over-voltage Stall Level (Fast)
F625
Continuing Stall Period (During Positive
Torque/Speed)
F452
Stall Prevention During Regeneration
F454
DC Injection Start Frequency
F250
DC Injection Braking Current
F251
DC Injection Braking Time
F252
Motor Shaft Fixing Control
F253
Motor Shaft Stationary Control Enable/Disable
F254
Emergency Off Mode Setting
F603
DC Injection Braking Time
F604
Emergency Off Activation of the FL Output
Enable/Disable
N/A
Number of Retries
F303
Restart Conditions
F301
Scan Rate
F312
Lock-on Rate
F313
HX7 ASD Programming and Operation Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]