Download Programming & Operation Manual

F235
F240
PG Speed Frequency #1
Direct Access Number — F235
Program ⇒ Frequency Setting Parameters ⇒ Speed Reference
Setpoints ⇒ PG
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
This parameter is used to set the gain and bias of the PG input terminal when a
shaft-mounted encoder is used as the feedback transducer while operating in the
Speed Control mode.
Minimum — -Max. Freq. (F011)
See PG Speed Reference #1 (F234) for further information on this setting.
Units — Hz
Maximum — Max. Freq. (F011)
This parameter sets PG Speed Frequency #1 and is the frequency that is
associated with the setting of PG Speed Reference #1 while operating in the
Speed Control mode.
PG Speed Reference #2
Direct Access Number — F236
Program ⇒ Frequency Setting Parameters ⇒ Speed Reference
Setpoints ⇒ PG
Parameter Type — Numerical
Factory Default — 100.00
This parameter is used to set the gain and bias of the PG input terminal when a
shaft-mounted encoder is used as the feedback transducer while operating in the
Speed Control mode.
See PG Speed Reference #1 for further information on this setting when used
for Speed control.
Changeable During Run — Yes
Minimum — -100.0
Maximum — 100.0
Units — %
This parameter sets the PG input level that is associated with PG Speed
Frequency #2 while operating in the Speed control mode.
PG Speed Frequency #2
Direct Access Number — F237
Program ⇒ Frequency Setting Parameters ⇒ Speed Reference
Setpoints ⇒ PG
Parameter Type — Numerical
Factory Default — 80.00
This parameter is used to set the gain and bias of the PG input terminal when a
shaft-mounted encoder is used as the feedback transducer while operating in the
Speed Control mode.
See PG Speed Reference #1 for further information on this setting when used
for Speed control.
Changeable During Run — Yes
Minimum — -Max. Freq. (F011)
Maximum — Max. Freq. (F011)
Units — Hz
This parameter sets PG Speed Frequency #2 and is the frequency that is
associated with the setting of PG Speed Reference #2 while operating in the
Speed Control mode.
Startup Frequency
Direct Access Number — F240
Program ⇒ Special Control Parameters ⇒ Frequency Control
Parameter Type — Numerical
Factory Default — 0.10
The output of the drive will remain at 0.0 Hz until the programmed speed value
exceeds this setting during startup. Once exceeded during startup, the output
frequency of the drive will accelerate to the programmed setting.
Output frequencies below the Startup Frequency will not be output from the
drive during startup. However, once reaching the Startup Frequency, speed
values below the Startup Frequency may be output from the drive.
90
Changeable During Run — Yes
Minimum — 0.0
Maximum — 10.0
Units — Hz
HX7 ASD Programming and Operation Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]