Download Users Manual
Transcript
automatically converted to uppercase. Commands received without a proper address will be ignored. For example, to see the current scale stored in the unit, send the showin command: S01 showin <CR> Where 01 is the address shown in the power-on message and <CR> is the carriage return or ENTER key. The unit will respond by displaying the current settings for the input channels. The asterisk (*) indicates the command was successfully interpreted and executed. An incorrect command will result in a question mark (?) being displayed: ? * 3.1.2 Command Format In this manual, the commands listed for the HI-Q will be given in the following format: COMMAND<arg1, arg2> [arg3: opt1 opt2] [opt3, opt4, opt5] <arg1> = [opt1] = The name of the command is shown in BOLD type. Required arguments are placed in <triangle> brackets and optional arguments are in [square] brackets. A colon (:) after an argument means one of the options after it must also be specified. For arguments separated by commas (,) pick only one of the listed choices. For arguments separated by spaces, any number of the arguments may be specified. The <arg1>= and [opt1]= boxes show the allowed parameter values. Empty brackets [] indicate no parameter is specified. Commands will be executed after the HI-Q receives a carriage return or ENTER key. For example: STREAM<n>= [off serial disp1 disp2 disp3 dac1] STREAM<n> [+,-: serial disp1 disp2 disp3 disp4 dac1 dac2 pc] Determines which outputs are affected by stream <n>. []= Shows current outputs affected by stream <n> <n>= 1,2,3,4,5,6,7 [off]= [serial]= [disp1]= [disp2]= Removes all outputs from stream <n> Sends stream <n> data to serial output Sends stream <n> data to display #1 Sends stream <n> data to display #2 [disp3]= [disp4]= [dac1]= [dac2]= Sends stream <n> data to display #3 Sends stream <n> data to display #4 Sends stream <n> data to DAC #1 Sends stream <n> data to DAC #2 A ‘+’ before an argument adds that argument to the existing output list for stream <n>. A ‘-’ before an argument removes that argument from the existing output list for stream <n>. This command has one required argument (<n>) and two types of optional arguments. For the first option, STREAM<n>= is followed by OFF or a combination of the other arguments: STREAM1= serial, disp1, dac1 STREAM2= STREAM3= off (Sends stream 1 data to the serial port, dac1) (Shows current stream 2 values) (Removes all outputs from stream 3) For the second option, a (+) or (-) precedes each option: Stream1 -serial Stream1 +dac2 -dac1 (Removes serial output from previous stream 1 list) (Removes dac1 output from stream1 and adds dac2 output) 10