Download Users Manual

2.
Quick Start Guide
This section explains how to remove the HI-Q controller from its box and put it into operation. Its goal is to familiarize the user with
the HI-Q.
2.1
Unpacking the Unit
While unpacking the HI-Q unit, inspect it carefully for damage or missing items. If an item is missing or broken, contact your place of
purchase immediately. The HI-Q shipping package contains:
(1) HI-Q programmable intelligent controller
(1) User’s Manual (this manual)
Mounting hardware (self locking nuts (4), flat washers (4), spacers (8)
Note: All matting connectors are included
2.2
Power Requirements
The standard HI-Q requires 5Vdc ±5% across its terminals and draws a nominal of 1.5A current. Other power supply options available
are:
10-32Vdc (24Vac) &
90-265Vac (100-360Vdc)
With either of these options, an isolated 5V, 50mA power source is provided at the rear of the unit on terminals TS3-1 and TS3-2. It
may be used to power external devices if care is taken not to exceed its maximum power rating. See the Power Supply Notes on page
55 for information regarding power supply wiring and voltage requirements when using long cable runs.
2.3
Applying Power to the Unit
Refer to Power Supply Options on page 21 to determine which HI-Q terminals are for power. To reduce the risk of electric shock,
make all connections while power is disconnected.
2.4
A Quick Demo
To verify proper HI-Q operation, run the display demo. Pressing any keypad key will halt the demo.
1.
Disconnect power from the unit.
2.
Hold down any one (1) keypad key.
3.
Reconnect power.
8