Download Users Manual
Transcript
12.3.5 Command execution Actions can also be used to execute one of three user selected commands. Any valid command can be selected with the CMD command. The commands are executed as if they had been sent directly to the serial input. If more than one alarm tries to execute a command, only the highest priority alarm will have its command executed. CMD<n> [command] Defines command <n> <command>= Any valid command (without ‘S’ + the device address) <n>= 1,2,3 Example: S01 cmd1 stream1-disp1 causes stream1 data to be removed from disp1 after cmd1 is activated by an alarm. 12.3.6 Run/stop control The last action that an alarm can perform is to stop the HI-Q from running. This action is equivalent to entering the STOP command from the serial port. All streams and analog outputs will remain at their current values and the HI-Q will stop reading and processing inputs. 41