Download Users Manual

[0]= Display OFF
[1]= Lowest intensity
[4]= Highest intensity
Example: S01dint1 changes the display intensity to low brightness. Mainly used for night time use onboard ocean going ships.
DL1 [ffff]
[]= Shows current DAC1 Lolimit
[ffff]= Sets DAC1 Lo limit to [ffff]
Example: S01dl1 3 sets the analog output low limit to 3mADC when the 4-20out is ordered.
DLFLASH
Causes entire bargraph to flash when display reaches a limit. Hi and Lo limits flash at a slow speed, while Hi Hi and Lo Lo limits flash at a
faster speed.
Example: S01dlflash
DLIMOFF (TBS, 123 and 124 series)
Turns off limit marks for all bargraph displays. Bargraphs will still change color and/or flash when reaching a limit, but the limit marks will
not show.
Example: S01dlimoff
DLIMON (TBS, 123 and 124 series)
Turns limit marks on for all bargraph displays
Example: S01dlimon
DLNFLASH
Turns off flashing when display reaches a limit
DMODE1 [BOT, BI] (TBS, 123 and 124 series)
[BOT]= Set bargraph to illuminate in a clockwise direction.
[BI]= Set bargraph to illuminate in a bi-direction mode. Used mainly to display positive and negative values such as charge / discharge rate
of batteries in power plants.
DOFFSET1 [ffff]
[]= Show current DAC1 output offset
[ffff]= Set DAC1 output offset to [ffff]
DSCALE1 [ffff]
[]= Show current DAC1 output scale
[ffff]= Set DAC1 output scale to [ffff]
DSYM (TBS only)
Causes all bargraph bars to change to the limit color when a limit is reached
DSYMOFF (TBS only)
Allows only the bargraph bars beyond a limit to change to the limit color
59