Download TeSys U LUCM and LUCMT Multifunction Control Unit

Detailed Startup and Adjustments During Use
Sub-Program 3_Setup
At a Glance
The sub-program 3_Setup provides access to all basic settings.
Each function may be modified in any mode. The LUCM settings are different from the LUCMT settings.
WARNING
INCORRECT SETTINGS
The settings (parameters) may be changed in "Run" mode.
Values may be defined via the network.
External programming peripherals must have write privileges.
The power must be applied to adjusted values.
Use a password to prevent illicit changes.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
3_Setup for LUCM
The current function is displayed on the second line of the display.
Sub-prog.
(line 1)
Function
(line 2)
3_Setup
31_FLASet
32_TestTrip
33_Pause
34_Language
31_FLASet for LUCM
The FLA value represents the nominal current absorbed by the motor. This value is used in most
protection functions.
Adjustments are made to the nominal current at full load. You should use the value provided on the motor
plate.
The range of settings depends on the reference of the multifunction control unit (six possible references).
The minimum value is displayed by default. Values are increased/decreased in steps of 1.
LUCMX6BL
LUCM1XBL
LUCM05BL
LUCM12BL
LUCM18BL
LUCM32BL
= 0.15 A
(min.)
to
? 0.6 A
(max.)
= 0.35 A
(min.)
to
? 1.4 A
(max.)
= 1.25 A
(min.)
to
?5A
(max.)
=3A
(min.)
to
? 12 A
(max.)
= 4.5 A
(min.)
to
? 18 A
(max.)
=8A
(min.)
to
? 32 A
(max.)
WARNING
INCORRECT FLA SETTING
The FLA setting must represent the nominal current when the motor is at full load.
The FLA setting defines the default values of the other motor protection functions.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
1743237 03/2009
41