Download Load Cell Input Module User`s Manual

APPENDICES
(4) Program example (automatic setting)
(a) Two-point setting and two-point calibration
A
Simultaneous request interlock
Two-point calibration start flag
Two-point calibration mode switch
request: ON
Operating condition setting command
A
Conversion enable
Operating condition setting request: ON
Operating condition setting command
Operating condition setting request: OFF
Load cell rated capacity
Load cell rated output
Number of load cells in connection
Weighing platform weight
zero offset: Used
Maximum weighing capacity setting
Minimum division
Decimal point position
Standard weight setting
Installation site gravitational acceleration
Calibration site gravitational acceleration
Two-point setting: Write
Two-point calibration method setting:
Automatic setting
Two-point setting request: ON
259
Appendix 4 Two-point Calibration when a Sequence Program is Used
Appendix 4.2 Program example for two-point calibration
Unit