Download Roller Shutter Remote Control System User Manual

EMC/EMI Compliance Statement: CE Mark Declaration of Conformance
Manufacturer's Disclaimer Statement: The information in this document is subject to change without notice and
does not represent a commitment on the part of the vendor. No warranty or representation, either expressed or
implied, is made with respect to the quality, accuracy or fitness for any particular purpose of this document. The
manufacturer reserves the right to make changes to the content of this document and/or the products associated
with it at any time without obligation to notify any person or organisation of such changes. In no event will the
manufacturer be liable for direct, indirect, special, incidental or consequential damages arising out of the use or
inability to use this product or documentation, even if advised of the possibility of such damages. This document
contains materials protected by copyright. All rights are reserved. No part of this manual may be reproduced or
transmitted in any form, by any means or for any purpose without expressed written consent of its authors. Product
names appearing in this document are mentioned for identification purchases only. All trademarks, product names
or brand names appearing in this document are registered property of their respective owners.
Contents
1
Introduction
1.2
Technical Specification
1.3
Number Types
2
Operation
2.1
Registration
2.2
Command Message Format
2.3
Master Number Setup
2.4
Allowing Master Control for All Users
2.5
Adding a User Number
2.6
Removing a User Number
2.7
Viewing the Valid Number List
2.8
Finding a Number in the Memory
2.9
Clearing All Numbers and Settings
2.10
Result Acknowledgement Message
3
Relay Operation/Access Control
3.1
Enabling Any Number and Disabling Open-on-Call
3.2
Select the Call Output Relay
3.3
Call Reject
3.4
Connecting a Call
3.5
DTMF Keypad Control
3.6
Relay Status Message
3.7
Relay Activation Mode
3.8
Relay Activation Time
3.9
De-activating Voicemail
3.10
ON & OFF Commands
3.11
OPEN and CLOSE Commands
4
Dialling Commands
4.1
Dial Now
4.4
Changing the Maximum Ring Time
4.5
Changing the Maximum Call Time
4.6
Changing the Maximum Silence Time
5
Setup
5.1
SIM Keep Alive Text
5.2
Signal Strength Indicator
5.3
Power Up/Reset Text Message
6
Installation
6.1
Power Connection
6.2
Output Connection
6.3
Antenna Connection
6.4
Mounting
6.5
Schematic Diagram
7
Command Set Summary
3
3
3
3
4
5
5
6
6
6
6
7
7
7
8
8
8
8
8
8
9
9
9
10
10
11
11
11
11
11
11
12
12
12
12
13
13
13
14
14
15
16
6.5
Schematic Diagram