Download VPFlowScope probe user manual

Transcript
Mechanical installation
6. Open the ball valve and slowly push the VPFlowScope
prob e completely in.
7. Push the probe in till it hits the bottom of the pipe. Now
place another mark on the probe.
8. Retrieve the probe half the pipe diameter. Adjust the
safety line (and strap) to keep the VPFlowScope prob e in
place. Keep in mind to align the VPFlowScope prob e
with the flow direction.
9. Gently tighten the compression fitting. Do not over
tighten to prevent damage to the probe. Pull the probe to
check if the compression fitting is tight enough.
10. Now your VPFlowScope probe is installed.
© 2013 Van Putten Instruments BV | MAN-VP-SPROBE-UK | Revision:1 | Date:29-11-2013
15