Download 1 - Yamaha Robotics
Transcript
3-4 Connections 3-4 Connections 3-4-1 Connecting the robot cables Plug the cable from robot body into the robot cable connector, then cover the connection with the hood. Installation and Connections 3 3-5 Setting the parameters Specify a load capacity parameter setting (PRM3) which is equivalent to the sum of the end effector and workpiece weights. For setting procedure details, refer to the ERCD/ERCX controller user's manual. 3-6 Trial Operation Execute a return-to-origin operation. Begin automatic operation in the low-speed mode. If no problems are observed, execute high-speed automatic operation. 3- 6