Download FE/PWO System Installation

Press after all values are entered. (Note: You cannot set minutes to 0. If
you attempt to set minutes at 0, the program will use the previous minutes
setting)
4. Set the duration time for SV-2 to be open.
iii.
a. Once an acceptable duration time as been established, the duration timer should
not have to be reset
b. Toggle to the screen titled, SET SAMPLE FLOW DURATION
i.
Press or to toggles through all screens
ii.
Or Press to toggles through the three timer screens only
c. Select hours
i.
Press F2 and then Press
ii.
Or Press or until the cursor is just to the left of hours and then Press
d. Set hours value on sub screen
i.
Select numerical position
1.
Press or
ii.
Select numerical value for each position
1.
Press or
iii.
Press after all values are entered
e. Select minutes
i.
Press F3 and then Press
ii.
Or Press or until the cursor is just to the left of minutes and then
Press
f. Set minutes value on sub screen
i.
Select numerical position
1.
Press or
ii.
Select numerical value for each position
1.
Press or
2.
Press after all values are entered
5. Toggle to the screen titled, SAMPLE TIME UNTIL START - TIME LEFT ON
SAMPLE
a. Press or to toggles through all screens
b. Or Press to toggles through the three timer screens only
6. Start sample cycle
a. Press F1,
i.
A seconds timer will show on the screen and SAMPLE TIME UNTIL
START and TIME LEFT ON SAMPLE will show time remaining on their
respective timers as time elapses
ii.
All timer screens will show the message COUNTING DOWN TO SAMPLE
TIME until SV-2 open, then the message will change to SAMPLE FLOW ON
iii.
When the cycle is complete, SAMPLE TIME UNTIL START and TIME
LEFT ON SAMPLE will reset to their previous value and all timer screens
will show the message SAMPLE CYCLE OFF.