Download Wireless Security System INSTALLATION AND PROGRAMMING

22
2. From the screen of each device press the
ming submenu.
dNXXX ---#000000
DevicedN name
ENT
3. Programming
button to enter its parameter program-
ENT
Three submenus can be programmed here.
Device01 name
1)Change name
ENT
1)Change name
Device01 name
-
Device01 name
2)Enable/Disable
ENT
Device01 name
ENABLED
Device01 name
3)Remove
ENT
Device01 name
remove?
1)Change name
1
2
3
4
5
6
7
8
9
0
disable?
enable?
ENT
are you sure?
The name of the wireless device can be freely edited in this
menu. Use the keypad to select the letters to write the new
name. A cursor is positioned under the letter to be edited. After
the new letter is selected, the cursor automatically moves on to
the next letter to be edited. A table with the available symbols is
provided in §1.3.4, page 8.
Attention: In this mode you can switch over the avaliable Latin and Cyrillic symbols and letters by single
pressing the PRG button.
2)Enable/Disable The menu provides the opportunity for the device to be disabled or enabled. A disabled device is indicated by the letter D
in the field of its current status; the system operation shall not
be interfered with by its performance, but shall respond in case
of a message.
Example for a disabled device: -D-.
3)Remove
Use the
ENT
The menu provides an opportunity for complete deletion of the
device from the system memory and for enrolling a new one
in its place. Double confirmation is required for the request to
delete the device.
The position of every deleted device stays empty. If there are
some empty positions, and a new device had to be enrolled it
would be recorded into first empty position in the system memory. For example, if positions 7 and 15 are free the first new
device would be recorded in position 7.
button to confirm all entered data and changes.